Product Introduction
7.1 The alias of the aluminum water is aluminum water casting ladle. The lip-pour ladle in the aluminum water is used for casting room casting operation. After receiving the aluminum water in front of the furnace, the traveling crane will run to the foundry mold for casting. There are mainly. several constituent parts below: suspender assembly, safety jaw, barrel, retarding mechanism,handwheel, motor, and declutching device (manual aluminum water casting ladle is without motor). or declutching device).
1) The center of gyration is reasonably chosen, with convenient operation, and self-actuatedresetting can be performed basically after casting. Precise processing, reasonable design and effective avoidance of "kowtow" in the process of using the aluminum water casting ladle.
2) The worm gear tooth is made from aluminum bronze, and the worm gear is of 45# steel andundergoes the tempering surface quenching treatment to make the transmission steady, with. reliable self-locking performance.
3) The suspender is of forging, which is more reliable and safer compared to steel plate weld. assembly. The structure of ladle bottom is of combination of taper, bottom rim and welding, prolonging the service life and ensuring the operator's safety. The cylinder body is of hightemperature resistance hot rolled carbon steel plate which contains a few impurities (such as S andP) and whose yield strength is higher than 235Mpa and strength of extension reaches to 460Mpa. Because the steel is standard killed steel, its welding property is very good, with fissure not easily. occurring to the welding structure, its plasticity and toughness are also very excellent and its performance is much higher than that of rimmed steel.
4) The main body, suspender, reducer casing and handwheel are installed with hinge snap-gaugefor locking at any time.
5) The self-aligning bearing is installed between two trunnions and suspender, with goodconsistency.
6) The aluminum water casting ladle is set with unique anti-splash device to effectively prevent themolten aluminum from being splashed into the reducer casing when working.
7) NC blanking, NC welding, special tool processing, uniform standard accessories, and professional. installation.
8) Manual type and manual/electric type. The electric drive type is of double worm gear pair three-stage drive. Although the manufacturing requirement is high, it's safe and labor-saving, withflexible drive and good bidirectional reversibility. The manual drive type is of worm gear andworm two-stage transmission. The worm drive is of reliable self-locking, with safe and reliable. use, convenient operation, light and smooth and steady drive, bidirectional rotation and good reversibility.
7.2 The lip-pour ladle preheating device in the aluminum water is also called as ladle baker andmainly used for quickly and evenly heating the lip-pour ladle lining to an appropriate processtemperature to ensure the temperature of the molten aluminum after the aluminum water is added and prolong the service life of the aluminum water casting ladle lining.
The natural gas (NG) or liquefied petroleum gas (LPG) is used as the fuel.
The combustion is sufficient, energy-saving and environmentally friendly.
It's suitable for many high aluminum water casting ladle.
The conventional high-speed gas burner and self-preheating burner are equipped.